Operating instructions

Attaching Memory Unit Type D 128MB, Memory Unit Type E 256MB (SDRAM Module)

Note

❒ Be sure to return the provided screwdriver to its original position on the

inside of the front cover.

❒ After finishing the installation, you can check the memory unit is properly

installed: Print the configuration page from the [List/Test Print] menu. If it is

installed properly, the memory capacity will appear under “Total Memo-

ry” on the configuration page.

❒ The table below shows the total SDRAM module capacities.

❒ If the memory unit is not properly installed, repeat this procedure. If you

cannot install it properly even after reinstallation, contact your sales or ser-

vice representative.

Reference

For printing the configuration page, see “Test Printing”, Quick Installation

Guide.

Install the controller board carefully. For details, see p.19 “Caution when

re-installing the controller board”.

Standard Extended Total

256 MB 128 MB 384 MB

256 MB 256 MB 512 MB