Operating instructions

Exterior: Rear View
11
1
Exterior: Rear View
1. Controller Board
Slide this out to install options such as the
memory unit, user account enhance unit
or printer hard disk. Plug cables such as
the USB cable and Ethernet cable into
their connectors.
2. Ethernet Port
Use a network interface cable to connect
the printer to the network.
3. USB Port
Use a USB cable to connect the printer to
the host computer.
4. Optional Interface Board Slots
Insert an optional IEEE 802.11b interface
unit, wireless interface board, or 1284 in-
terface board in this slot. Up to two inter-
face board can be inserted at a time.
5. Expansion Card Slots
Install expansion cards in these slots.
There are three slots.
When you use the expansion card, use
the center slot.
6. Front Cover (A) Open Levers
7. Left Cover
Open this cover when replacing the pho-
to conductor unit (PCU), intermediate
transfer unit or waste toner cartridge.
8. Power Cable
The power cable is separated. Connect
the power cable to the printer.
The power cable is fixed to the back side.
AQC200S