Service manual

Error Messages
SM 4-23 M001
Trouble-
shooting
1st/2nd Message Problem/Solution
menu on the machine operation panel
 Push [Form Feed]
 Cancel the print job.
Change Setting
Tray #/ Paper Size:, Paper Type:
The paper size/paper type settings in the application
program and printer driver do not match.
Do one of the following:
 Load the tray with the correct paper
 Change the paper size using the dial or the
special paper size setting menu on the operation
panel.
 Push [Form Feed]
 Cancel the print job.
Close Duplex Unit Cover
The duplex unit cover is open.
 Close the duplex unit cover.
Close Front Cover
The front cover is open.
 Close the front cover.
Close Rear/Paper Exit Cover
The paper output tray cover or the rear cover is open,
or both covers are open.
 Check the covers, make sure they are closed.
DHCP assigned, Cannot change
DHCP has been enabled to assign network
addresses of: IP address, subnet mask, gateway
address.
 Disable DHCP in host interface network setup to
change any of these addresses.
Error: Enter 10, or 26 Characters
Number of hex characters entered for the WEP key is
incorrect.
 Enter correct number of characters.
Error: Enter 5, or 13 Characters
Number of ASCII characters entered for the WEP key
is incorrect.
 Enter correct number of characters.
Rev. 11/03/2009
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA