Quick Start Guide

Setting of Original Feed Type
123
6
❖ When You Set an Original in the ADF
Note
❒ Originals are normally rectangular ( ) or horizontally long ( ). However,
the table above uses squares to make original orientation easier to under-
stand. Even if the actual shape of the original is different, the combination
of original orientation and the orientation specified on the scanner driver
does not change.
Original Settings
This section explains the settings for the scanning the sides of originals.
One-sided original
This section explains the settings for scanning only one side of originals.
A Press [Original Feed Type].
B In [Original Settings], select [1 Sided Original].
C Press [OK].
Original orientation Control Panel Key
top edge placed first
top edge touches rear of ADF