User's Manual

Message Causes Solutions
"Some invalid destination(s)
contained. Do you want to
select only valid
destination(s)?"
The specified group contains
e-mail destinations and Scan
to Folder destinations, either
of which are incompatible
with the specified
transmission method.
In the message that appears at each
transmission, press [Select].
"Some of selected files are
currently in use. They could
not be deleted."
You cannot delete a file
which is waiting to be
transmitted ("Waiting to
send data..." status
displayed) or whose
information is being
changed with
DeskTopBinder.
Cancel transmission ("Waiting to send
data..." status cleared) or the
DeskTopBinder setting, and then delete
the file.
"Some page(s) are almost
blank. To cancel press the
Stop key."
The first page of the
document is almost blank.
The original's blank side might have
been scanned. Be sure to place your
originals correctly.
"The entered file name
contains invalid character(s).
Enter the file name again
using any of the following 1
byte characters. " 0 to 9 ", "
A to Z ", " a to z ", " . - _""
The file name contains a
character that cannot be
used.
• Check the file name specified at
the time of scanning. For details
about characters that can be used
in file names, see "Available
Characters and How to Enter
Them", Getting Started
.
•
Check the file name specified at
the time of scanning. The file
name specified in the Sending
Scan Files to Folders function
cannot contain the following
characters:
\ / : * ? " < > |
The file name cannot start or end
with a period ".".
"The number of destinations
that can be entered
manually at the same time is
as shown above."
The e-mail has too many
destinations.
Split the destinations into two or more
groups.
When Messages Are Displayed on the Control Panel
191