Service manual

Dedicated Transmission Parameters
D127/D128 5-86 SM Appendix
Switch 02
No FUNCTION COMMENTS
0-3
Initial Tx modem rate
If training with a particular remote terminal
always takes too long, the initial modem
rate may be too high. Reduce the initial Tx
modem rate using these bits.
For the settings 14.4 or kbps slower,
Switch 04 bit 4 must be changed to 0.
 Do not use settings other than
listed on the left. If the setting is
"Disabled", the bit switch setting is
used.
Bit3 Bit2 Bit1 Bit0 bps
0 0 0 0 Not used
0 0 0 1 2400
0 0 1 0 4800
0 0 1 1 7200
0 1 0 0 9600
0 1 0 1 12000
0 1 1 0 14400
1 1 0 1 31200
1 1 1 0 33600
1 1 1 1 Disabled
Other settings: Not used
4-7 Not used Do not change the settings.