Service manual

Bit Switches
D127/D128 5-44 SM Appendix
7
Operating selection on not
corresponding F-codebox with
received SUB
0: Disconnect
1: Receive
This function also applies to SID/PWD only
reception.
Communication Switch 18 [SP No. 1-104-025]
No FUNCTION COMMENTS
0-4 Not used Do not change the settings
5
IP-FAX dial-in routine function
Enabled/Disabled switch
0: Disable / 1: Enable
Determines whether IP-FAX dial-in routine
function which has the same function as PSTN
dial-in routine does on IP-FAX, enable/disable.
Default is 0 (Disable).
6-7 Not used Do not change the settings
Communication Switch 19 - Not used (do not change the settings)
Communication Switch 1A - Not used (do not change the settings)
Communication Switch 1B [SP No. 1-104-028]
No FUNCTION COMMENTS
0-7
Extension access code (0 to 7)
to turn V.8 protocol On/Off
0: On
1: Off
If the PABX does not support V.8/V.34 protocol
procedure, set this bit to “1” to disable V.8.
Example: If “0” is the PSTN access code, set bit 0
to 1. When the machine detects “0” as the first
dialed number, it automatically disables V.8
protocol. (Alternatively, if “3” is the PSTN access
code, set bit 3 to 1.)