Service manual

Bit Switches

SM Appendix 5-25 D127/D128

Appendix:

Fax Trouble-

Shooting

Guide

I-fax Switch 03 - Not used (do not change the settings) [ SP No. 1-102-004]

I-fax Switch 04 [SP No. 1-102-005]

No FUNCTION COMMENTS

Subject for Delivery TX/Memory Transfer

This setting determines whether the RTI/CSI registered on this machine or the

RTI/CSI of the originator is used in the subject lines of transferred documents.

0: Puts the RTI/CSI of the originator in the Subject line. If this is used, either the RTI

or CSI is used. Only one of these can be received for use in the subject line.

1: Puts the RTI/CSI registered on this machine in the Subject line.

When this switch is used to transfer and deliver mail to a PC, the information in the

Subject line that indicates where the transmission originated can be used to

determine automatically the destination folder for each e-mail.

Subject corresponding to mail post database

0: Standard subject

1: Mail post database subject

The standard subject is replaced by the mail post database subject in the following

three cases:

1) When the service technician sets the service (software) switch.

2) When memory sending, delivery specified by F code or SMTP reception is done.

3) With relay broadcasting (1st stage without the Schmidt 4 function).

 This switch does not apply for condition 3) when the RX system is set up

for memory sending, delivery by F-code, sending with SMTP RX and when

operators are using FOL (to prevent problems when receiving

transmissions).

2-7 Not Used