Service manual

Fax Error Codes
D127/D128 4-20 SM Appendix
Code Meaning Suggested Cause/Action
22-01
Memory overflow while
receiving
 Wait for the files in the queue to be sent.
 Delete unnecessary files from memory.
 Transfer the substitute reception files to an
another fax machine, if the machine’s printer is
busy or out of order.
 Add an optional SAF memory card or hard
disk.
22-02
Tx or rx job stalled due to
line disconnection at the
other end
 The job started normally but did not finish
normally; data may or may not have been
received fully.
 Restart the machine.
22-04
The machine cannot store
received data in the SAF
 Update the ROM
 Replace the FCU.
22-05
No G3 parameter
confirmation answer
 Defective FCU board or firmware.
23-00
Data read timeout during
construction
 Restart the machine.
 Replace the FCU.
25-00
The machine software
resets itself after a fatal
transmission error
occurred
 Update the ROM
 Replace the FCU.
F0-xx V.34 modem error  Replace the FCU.
F6-xx SG3 modem error
 Update the SG3 modem ROM.
 Replace the SG3 board.
 Check for line noise or other line problems.
 Try communicating another V.8/V.34 fax.