Service manual

Fax Error Codes
D127/D128 4-4 SM Appendix
Code Meaning Suggested Cause/Action
0-15
The other terminal is not
capable of specific
functions.
The other terminal is not capable of accepting the
following functions, or the other terminal’s memory
is full.
 Confidential rx
 Transfer function
 SEP/SUB/PWD/SID
0-16
CFR or FTT not detected
after modem training in
confidential or transfer
mode
 Check the line connection.
 Replace the NCU or FCU.
 Try adjusting the tx level and/or cable
equalizer settings.
 The other end may have disconnected, or it
may be defective; try calling another machine.
 If the rx signal level is too low, there may be a
line problem.
Cross reference
See error code 0-08.
0-20
Facsimile data not
received within 6 s of
retraining
 Check the line connection.
 Replace the NCU or FCU.
 Check for line problems.
 Try calling another fax machine.
 Try adjusting the reconstruction time for the
first line and/or rx cable equalizer setting.
Cross reference
Reconstruction time - G3 Switch 0A, bit 6
Rx cable equalizer - G3 Switch 07 (PSTN)
0-21
EOL signal (end-of-line)
from the other end not
received within 5 s of the
previous EOL signal
 Check the connections between the FCU,
NCU, & line.
 Check for line noise or other line problems.
 Replace the NCU or FCU.
 The remote machine may be defective or may
have disconnected.
Cross reference
Maximum interval between EOLs and between
ECM frames - G3 Bit Switch 0A, bit 4