Service manual

TRANSFER AND PAPER TRANSPORT UNIT
SM 3-35 G130/G312
Replacement
and
Adjustment
7. Lay the transfer unit on its side.
8. Grasp the upper end of the transfer belt. Then pull the transfer belt [A] up and
out.
9. Clean the transfer belt mark sensor [C] with Blower brush.
NOTE: Clean the drive rollers with a damp cloth if they are dirty.
When you reinstall the transfer belt
The transfer belt must be installed with the mark “[B]” at the front side of the
machine.
Do the same procedures mentioned in 3.9.1 after you replace the transfer belt.
G130R592.WMFF
G130R593.WMFF
[A]
[B]
[C]