Service manual

LASER OPTICS
G130/G131 3-18 SM
When reassembling the laser optics-housing unit, follow the notes below.
Make sure that the clamp [A] is positioned between two binds [B], the harness [C]
is not bound by the clamp [D] and the clamp [E] is positioned between two binds
[F].
When you connect the harnesses from laser optics housing unit to the BCU, make
sure that the binds [E] are positioned and the binds [F] are positioned as diagram
shows.
Enter the SP mode and set "Disable" with SP2-920-1 after you replace the laser
optics-housing unit.
OK NG
OK
NG
OK
NG
G130R555.WMFF
G130R556.WMFF
[A]
[B]
[C]
[D]
[E]
Rear view
[F]
[E]
[F]