Service manual

OPTIONAL TRAY UNIT
SM 1-19 G130/G131
Installation
Adjusting the Height
1. Check the type of the optional paper tray:
• If the optional two-tray paper feed unit or the optional LCT is installed, go to
step 2.
• Go to “Main Body if either of them is not installed.
2. Tape the pads [A] to the right-hand side of the machine.
3. Put the machine on its right-hand side.
4. Remove the adjuster plates [B] ( x 2).
5. Change the height [C].
6. Install the adjuster plates again [D].
7. Remove the machine out of the box and stand it up.
8. Check that the height is correct, and remove the pads.
G130I534.WMF
G130I533.WMF
[B]
[C]
[D]
[A]