Service manual

OPTIONAL TRAY UNIT

SM 1-11 G130/G131

Installation

1.4 OPTIONAL TRAY UNIT

1.4.1 TWO-TRAY FINISHER

Accessory Check

Check the accessories and their quantities against the following list.

Description Q’ty

1. Duplex-unit support.................................................................... 1

2. Tray............................................................................................ 1

3. Link rail....................................................................................... 1

4. Link-rail holder ........................................................................... 1

5. Long screw M4x12..................................................................... 6

6. Short screw M4x8 ...................................................................... 2

INSTALLATION PROCEDURE

NOTE: This installation procedure uses the following symbols.

: Screw : Connector

CAUTION

Turn off the main switch of the printer and unplug its power cord before

you begin the installation procedure.

1. Remove all tape. Check that no tape remains

inside the front cover and on the left cover.

2. Fold the external tray [A].

B599I926.WMF

B599I914.WMF

[A]