Service manual

PRINTER FUNCTIONS
SM 6-87 G130/G131
Detailed
Descriptions
Paper Output Tray
You can select default output tray as follows: Menu > System > Output Tray. If a
print job does not specify an output tray or if the driver specifies the default tray, the
output tray selected with this UP mode will be used. If the output tray is selected
with the printer driver, this setting has priority over the default setting.
Output Tray Selected
• If the machine cannot print to the selected output tray, it prints to the default
paper output tray.
• If paper overflow is detected at the selected output tray, the controller suspend
printing.
Stapling
The optional two-tray finisher and booklet finisher can staple papers. Both finishers
support the following stapling positions:
[A]: One staple (vertical) is at the rear right
corner.
[B]: Two staples (vertical) are at the right
middle edge.
[C]: One staple (vertical) is at the front right
corner.
The two-tray finisher supports the following
stapling position (the booklet finisher does
not):
[D]: One staple (slant) is at the front right
corner.
The booklet finisher supports the following
stapling position (the two-tray finisher does
not):
[E]: Two staples (vertical) are at the center.
The table lists the number of papers that the finishers can staple.
Position Paper size
A4, B5, LT (81/2" x 11") A3, Ledger, Legal
Two-tray finisher [A][B][C][D] 50 sheets 30 sheets
[A][B][C] 50 sheets 25 sheets
Booklet finisher
[E] — 10 sheets
NOTE: For more paper sizes, see the specifications.
G130D582.WMF
[A]
[B]
[C]
[D]
[E]
Paper exit