Service manual

PRINTER
SM 1-9 G130/G131
Installation
Preparing the Printer
CAUTION
Make sure that the transfer belt is in its correct position before you move
the printer. If not, the transfer belt and the black PCU can get damaged.
1. Check that the transfer belt is in its correct position.
2. Remove the supports ( 1.3.4).
3. Remove the toner bottles to not let toner flow into the toner supply tubes when
you move the machine. This can cause the tube to get clogged with toner.
4. Put air packing into the toner cartridge holders to protect the toner supply
entrances. This does not let toner flow out to the toner cartridge holders.
5. Set the lock pin [A] (which comes
with the machine) in the transfer
belt unit.
NOTE: The lower end of the
transfer belt moves. The
surface of the belt and PCU
can get damaged by the
friction between them if you
transport the machine
without locking the belt.
6. Make sure there is no paper left in the paper trays. The fix down the bottom
plates with a sheet of paper and tape.
7. Empty out the waste toner bottle. Then attach securing tape not to let the bottle
from come out.
G130I507.WMF
[A]