Service manual

PRINTER
SM 1-7 G130/G131
Installation
1.3.4 MOVING THE MACHINE
CAUTION
Make sure that the transfer belt is in its correct position before you move
the printer. Otherwise the transfer belt and the black PCU can get damaged.
NOTE: This section assumes that you manually move the machine to a different
floor in the same building. See section 1.3.5 if you use transportation
equipment.
The supports on the paper feed unit or LCT make it difficult to move the machine.
You can remove them when necessary.
1. Check that the transfer belt is in the
correct position.
2. Remove the supports [A] from both
sides ( x 2 for each).
CAUTION: Install the supports again after you move the machine. If not, the
machine can tilt when you draw out a paper tray or while you service
the printer.
G130I506.WMF
[A]