Service manual

PAPER FEED
SM 6-47 G130/G131
Detailed
Descriptions
6.6.2 DRIVE – TRAY 1, TRAY 2, AND BY-PASS TRAY
The paper feed motor [A] drives the pick-up and feed mechanisms in tray 1 [E], tray
2 [F], and the by-pass tray [G]. It uses clutches and complex trains of gears (the
locations of the gear trains are indicated by dotted lines in the above diagram) to
do this.
When tray 1 and tray 2 are inside the machine, their pick-up rollers [H][K] are
always in contact with each top sheet of the paper stack. However, the pick-up
roller [P] of the by-pass tray stays away until the by-pass pick-up solenoid [Q] turns
on. When the paper feed clutch [B][C][D] turns on, the pick-up, feed [I][L][N], and
separation [J][M][O] rollers start rotating to feed the paper. The paper feed clutch
stays on until shortly after the registration sensor activates.
G130D541.WMF
G130D542.WMF
[A]
[K]
[C]
[L]
[M]
[H]
[B]
[I]
[J]
[D]
[P]
[N]
[O]
[E]
[F]
[G]
[Q]