Service manual

ManualsBrandsRicoh ManualsComputer equipmentAficio C7535n

PRINTER

G130/G131 1-6 SM

1.3.3 INSTALLATION AND SETTINGS

Refer to the Operating Instructions for the installation procedure. Make the

necessary settings for the service contract after you install the printer. Use caution

when you make the settings.

1. Check the contract type carefully before you do steps 2 and 3. You cannot

change some settings back again if you make an incorrect setting.

2. You must enable Meter Charge (SP5-930-001) for any meter click counter

contract. The default is “OFF” (disabled).

3. If you set Meter Charge to “ON”, you must set Counter Methods (SP5-045)

(developments/prints) in accordance with the contract ( 5.3.1). You cannot

change the setting back again if you change the setting from “Prints” (default)

to “Developments.”

The table shows the SP Mode settings related to service contracts.

Service Program Function

Meter Charge > ON/OFF

(SP5-930-001)

Enables or disables the Meter Charge. (Default: OFF

[Disabled])

When enabled:

• The Counter menu appears immediately after you push

the Menu key. The Counter Method (SP5-045) sets the

type of the counter.

• You can print the counter from the Counter menu.

When disabled:

• The Counter menu is not shown.

Meter Charge > Menu (SP5-

930-003)

Enables or disables the PM Alert for the PCUs, development

units, and fusing unit. (Default: Click 1 [Enabled])

When the PM Alert is enabled, a message is displayed

when one of the units needs to be replaced.

Meter Charge > Paper Feed

(SP5-930-004)

Enables or disables the PM Alert for the paper feed rollers.

(Default: No Alert [Disabled])

Meter Charge > Paper

Transfer (SP5-930-005)

Enables or disables the PM Alert for the transfer unit and

transfer-cleaning unit. (Default: No Alert [Disabled])

Counter Method (SP5-045) Tells the counter when to count (each development or each

print). (Default: 1 [Prints])

Double Count (SP5-104) Specifies whether the counter increase by +1 or by +2 when

the paper size is A3 or 11" x 17". (Default: OFF [by +1])

Telephone Number Setting >

Service (SP5-812-001)

Shows or sets the telephone number of the service

representative.

Telephone Number Setting >

Fax Telephone Number

SP5-812-002

Shows or sets the fax number of the service station. The

number is printed on the counter list when the Meter Charge is

enabled. The user can send a fax message with the counter

list.