Service manual
FIRMWARE UPDATE
G130/G131 5-98 SM
5.4.4 UPDATING
Procedure
1. Turn off the main power switch.
2. Disconnect the printer from the network
( 5.4.2).
3. Remove the slot cover [A] ( x 1).
4. Turn the label face of the SD card to the
front side of the printer, and insert it into
slot 3 [B].
5. Slowly push the SD card into the slot
until it clicks.
6. Make sure that the SD card is locked in
place.
NOTE: To remove the SD card, push it
in until it clicks, and release it slowly. The slot pushes out the SD card.
7. Turn on the main power switch.
8. Wait until a firmware name is shown on the display (about 45 seconds).
NOTE: The firmware name is read from inside the firmware. The firmware
name is not changed even if you change the file name on your PC.
9. If the necessary firmware name is shown on the display, go to the next step. To
use a different firmware, push the up-arrow key or the down-arrow key to find
the necessary firmware.
10. To confirm the firmware version, press the menu key twice after the firmware
name shows. This ensures that you have updated the correct firmware version.
11. To select the firmware, push the enter key. Make sure that a star (4) is added
to the firmware name.
12. If you update more than one firmware program at the same time, find each of
them and select each of them. Make sure a star is added to each firmware
name.
13. To select “Update Data”, push the up-arrow key or the down-arrow key.
G130S504.WMF
[A]
[B]