Service manual

ENGINE SERVICE MODE
G130/G131 5-68 SM
SP7-XXX (Data Log)
Working Time
*BCU Display: 00000000~99999999 min
7001
The number of prints and drive time for drum revolutions can be obtained by counting
the main motor revolution time. If the amount of time required for the drum to revolve
to print 1 copy increases, this data combined with the number of copies can be used
to analyze problems and could be useful for future product development.
[SC Counter]
*CTL [0 to 9999 / 0
/ 1/step]
7401
Displays the number of SC codes detected.
[Total Jam]
*CTL [0 to 9999 / 0
/ 1 sheet/step]
7502
Displays the total number of jams detected.
[Jam Location]
ON: On check, OFF: Off Check
7504
Displays the number of jams according to the location where jams were detected.
7504 001 At Power On *CTL
7504 003 Tray 1: ON *CTL
7504 004 Tray 2: ON *CTL
7504 005 Tray 3/LCT: ON *CTL
7504 006 Tray 4: ON *CTL
7504 008 Registration: ON *CTL
7504 009 External Tray: ON *CTL
7504 010 Internal Tray: ON *CTL
7504 011 Duplex: ON *CTL
7504 012 Duplex Exit 1: ON *CTL
7504 013 Duplex Exit 2: ON *CTL
7504 014 Duplex Exit 3: ON *CTL
7504 015 Duplex Feed: ON *CTL
7504 020 Mail Box Upper: ON *CTL
7504 021 Mail Box Lower: ON *CTL
7504 051 Tray 1: OFF *CTL
7504 052 Tray 2: OFF *CTL
7504 053 Tray 3/LCT: OFF *CTL
7504 054 Tray 4: OFF *CTL
7504 061 Registration: OFF *CTL
7504 063 External Tray: OFF *CTL
7504 064 Internal Tray: OFF *CTL
7504 065 Duplex: OFF *CTL
7504 066 Duplex Exit 1: OFF *CTL
7504 067 Duplex Exit 2: OFF *CTL
7504 068 Duplex Exit 3: OFF *CTL
7504 069 Duplex Feed: OFF *CTL
7504 090 Mail Box Upper: OFF *CTL
7504 091 Mail Box Lower: OFF *CTL
7504 100 Finisher Entrance *CTL
7504 101 Finisher Shift Tray 1 *CTL
7504 102 Finisher Shift Tray 2 *CTL
7504 103 Finisher Staple *CTL
7504 104 Finisher Exit *CTL
7504 105 Finisher Drive *CTL
7504 106 Finisher Tray Up/Down *CTL