Service manual

ENGINE SERVICE MODE
G130/G131 5-52 SM
[NVRAMUpload] NVRAM Upload #
5824
Uploads the UP and SP mode data (except for counters and the serial number) from
the NVRAM to an SD card.
[NVRAMDownload] NVRAM Download #
5825
Downloads the UP and SP mode data from an SD card to the NVRAM.
5828
[Network] Job spool settings/ Interface selection for Ethernet and wireless LAN
1284 Compatible
(Centro)
*CTL [0 or 1 / 1 / 1 / step]
0: Disabled, 1: Enabled
5828 050
Enables or disables 1284 Compatibility.
ECP (Centro) *CTL [0 or 1 / 1 / 1 / step]
0: Disabled, 1: Enabled
NOTE: This SP is activated only when SP5-828-
50 is set to "1".
5828 052
Enables or disables ECP Compatibility.
Job Spool *CTL [0 or 1 / 0 / 1 / step]
0: Disabled, 1: Enabled
5828 65
Enables/disables Job Spooling.
HD job Clear *CTL [0 to 1 / 1 / 1/step] Alphanumeric
0: OFF
1: ON
(Prints jobs before clearing job data)
5828 066
Treatment of the job when a spooled job exists at power on.
Job Spool (Protocol) *CTL [0 to 1 / 1 / 1/step]
0: Off, 1: On
Bit switch:
• Bit 0: LPR
• Bit 1: FPT
• Bit 2: IPP
• Bit 3: SMB
• Bits 4 to 7: Reserved
5828 069
Switches job spooling off or on and enables settings for job spooling protocols.
5828 084 Print Settings List *CTL Prints a list of NCS related parameters.
TELNET *CTL [0 to 1 / 1 / 1/step]
0: Disabled, 1: Enabled
5828 090
Enables or disables Telnet.
Web *CTL [0 to 1 / 1 / 1/step]
0: Disabled, 1: Enabled
5828 091
Enables or disables the Web monitor.
[HDD Init.] HDD Initialization
5832
Prepares the hard disk. Use this SP mode only when there is a hard disk error.