Service manual

ENGINE SERVICE MODE
SM 5-49 G130/G131
Service Tables
5801
[Memory Clear] ( 5.3.2)
5801 001 All Executes SP5-801-002 through 019.
5801 002 ENG All Resets or deletes the engine-related data.
5801 003 SCS Clears the system settings.
5801 004 IMH Clears IMH data. DFU
5801 005 MCS Clears MCS data. DFU
5801 008 PRT Clears the printer application settings.
5801 010 Web Service Clears the netfile application management files
and thumbnails, and initializes the job login ID.
5801 011 NCS Initializes the system default and interface settings
(IP address also), SmartNetMonitor for
Admin, WebStatusMonitor settings, and the
TELNET settings.
5801 014 DCS Setting Resets or deletes the DCS-related data.
5801 015 Clear UCS Setting Resets or deletes the UCS-related data.
5801 016 MIRS Setting Resets or deletes the MIRS-related data.
5801 017 CCS
Initializes the CCS (
Certification and Charge-
control Service
) settings.
5801 018 SRM Initializes the SRM settings
5801 019 LCS Setting Initializes the LCS settings and logs.
[EngineFreeRun] 5802
Performs a free run on the printer engine.
NOTE:
• The machine starts free run in the same condition as the sequence of A4/LT
printing from the 1st tray. Therefore, paper should be loaded in the 1st tray, but
paper is not fed.
• The main switch has to be turned off and on after using the free run mode for a
test.
5803
[Input Check] ( 5.3.3)
5804
[Output Check] ( 5.3.4)
[Destination]
Destination Code Display
*BCU [0 to 3 / 0 / - ]
0: DOM, 1: NA, 2: EURO, 3: ASIA
5808
Displays the destination code.
5809
[SC OFF] SC Detection ON/OFF *BCU [0 or 1 / 0
/ -] Alphanumeric
0: Enable, 1: Disable
ALL 5809 001
Enable or disables the service call detection. The SC codes (not related to the
waste toner vibrator) are all ignored when SP5-809-001 is enabled.
[SC Reset] 5810
Resets a type A service call condition. Turn the main power switch off and on after
resetting the SC code.