Service manual

ENGINE SERVICE MODE
SM 5-17 G130/G131
Service Tables
1916 [Idling Mode]
Mode Set *BCU [0 to 1 / 0 / 1 /step] Alphanumeric
0: OFF, 1: ON
1916 001
Executes the extra idling operation after the fusing unit becomes ready just after the
main switch has been turned on.
Idling Time *BCU [10 to 120 / 30 / 10 sec/step] 1916 002
Specifies how long the extra idling operation is executed.
PreJob Mode *BCU [0 or 1 / 0 / 1 /step]
0: OFF
1: ON
1916 003
Executes the extra idling operation (4 seconds) after the fusing unit becomes ready
when a print job arrives at the printer.
Idling Time SP: H *BCU [0 to 360 / 0 / 1 sec/step] DFU 1916 004
Specifies how long the extra idling operation is executed when special paper is
used.
Pre Job Mode WUP *BCU [0 to 3 / 1 / 1 /step] Alphanumeric
0: H: on, M: off
1: H: on, M: on
2: H: off, M: on
3: H: off, M: off
1916 005
Executes the idling operation if the process speed of a job meets this setting
(combination between high and middle speed) after meeting following conditions..
The idling operation continues until the fusing temperature reaches the printing
ready condition.
• Turning the main power on
• Recovering energy saver mode and off mode
• Jam recovery
• Door open
L: Low speed 81 mm/s (for all models)
M: Middle speed 125 mm/s (for G130) or 162 mm/s (for G131)
H: High speed 162 mm/s (only for G130)
PreJob Mode Norm *BCU [0 to 1 / 1 / 1 /step] Alphanumeric
0: OFF, 1: ON
1916 006
Executes the idling operation for 2 seconds if the fusing temperature reaches the
printing ready condition when receiving a job for middle thick paper in color printing
mode.
1917
[Env Condition] Environmental Correction Condition
Time *BCU [0 to 23.5 / 23.5 / 0.5 hour/step] 1917 001
The machine cancels the environmental correction for low temperature
(SP1-912) after a prescribed time has passed after the machine is turned on, or,
recovers from energy saver mode.