Service manual

ENGINE SERVICE MODE
SM 5-11 G130/G131
Service Tables
[Drum MT Speed] Drum Motor Speed Adjustment
1008
Adjusts the drum speed. This SP does not change the transfer belt speed.
1008 001 [CL] L *BCU
1008 002 [CL] M *BCU
1008 003 [Bk] L *BCU
1008 004 [Bk] M *BCU
1008 005 OHP *BCU
1008 006 MUSIC *BCU
1008 008 [Bk] H *BCU
[0 to 10/ 3
/ 1 /step] DFU
1008 009 [CL] L SP2 *BCU
1008 010 [Bk] L SP2 *BCU
1008 011 [CL] L SP3, 4 *BCU
1008 012 [CL] M SP3, 4 *BCU
1008 013 [Bk] L SP3, 4 *BCU
1008 014 [Bk] M SP3, 4 *BCU
1008 015 [Bk] H SP3, 4 *BCU
[0 to 10/ 3
/ 1 /step] DFU
1008 016 [CL] L TH2, 3, 4 *BCU
1008 017 [Bk] L TH2, 3, 4 *BCU
[0 to 10 / 3
/ 1 /step] DFU
1104
[Fusing Cont.] Fusing Control
Control Method *BCU [ 0 or 1 / 0 / - ] Alphanumeric
0: ON/OFF Control
1: Phase Control
1104 001
Selects the fusing control method.
NOTE: This mode can be used only for N. America models
Process Speed *BCU [ 0 to 8 / 4 (G130) or 5 (G131) / 1 /step]
0: CL: L
1: CL: M
2: OHP, Thick
3: B/W: L
4: B/W: H
5: B/W: M
6: CL: M MidThick
7: B/W: H MidThick
8: B/W: M MidThick
1104 025
Selects the power-on default target fusing operation temperature.
The target operating fusing temperature depends on the process speed. When the
machine is switched on, it starts warming up for the process speed specified in this
SP mode.
1104 [Fusing Stand By]
H: Offset Temp *BCU [ –20 to 20 / 15 / 1
o
C /step] 1104 026
Sets the heating roller offset temperature for the 1st print condition after the heating
roller temperature reaches the ready temperature.
P: Offset Temp *BCU [ –20 to 20 / 5 / 1
o
C /step] 1104 027
Sets the pressure roller offset temperature for the 1st print condition after the
pressure roller temperature reaches the ready temperature.
H: Offset Temp *BCU [ –20 to 20 / 15 / 1
o
C /step] 1104 028
Sets the heating roller offset temperature for the 1st print condition before the
heating roller temperature reaches the ready temperature..
P: Offset Temp *BCU [ –20 to 20 / 5 / 1
o
C /step] 1104 029
Sets the heating roller offset temperature for the 1st print condition before the
pressure roller temperature reaches the ready temperature..