Service manual

SERVICE PROGRAM MODE
SM 5-1 G130/G131
Service Tables
5. SERVICE TABLES
5.1 SERVICE PROGRAM MODE

CAUTION
Before you start the service program mode, make sure that the printer is
not processing data. The Data In LED lights or blinks when the printer is
processing data.
5.1.1 HANDLING SERVICE PROGRAM MODE
IMPORTANT
Do not let the user get access to the service program mode. If a person other
than service representatives gets access to the service program mode, the
machine quality is not guaranteed.
Starting SP Mode
Start the service program mode as shown in procedure A or B.
NOTE: The printer goes offline status while the service program mode is used.
A: When the main power switch is off
1. Push the on-line key [A] and the escape key [B] and hold them down.
2. Turn on the main power switch.
3. Hold the keys until the message “SYSTEM ver X.XX” is shown (where X.XX is
the firmware version).
B: When the main power switch is on
1. Push the up arrow key [C] and down key [D] together for 5 seconds or more.
2. Push the enter key. The message “SYSTEM ver X.XX” is shown (where X.XX
is the firmware version).
Enter
Escape
From Feed
Job Reset
Online
Menu
Data In
Alert
Power
G130S501.WMF
[A]
[B]
[C]
[D]
[E]