Service manual

FUSING
G130/G131 3-38 SM
3.11 FUSING
CAUTION
Be careful when you handle the fusing unit. It is very hot.
3.11.1 FUSING UNIT
1. Turn the main switch off.
2. Detach the finisher from the machine if it is installed.
3. Open the duplex inverter unit if it is installed.
4. Open the left door. Then pull it out.
5. Fusing unit [A]
6. Turn the main switch on. The machine starts initialization for the new unit.
If the customer uses thick paper, make some test prints on a sample of the paper
used by the customer after you replace the fusing unit. Adjust the line speed for
thick paper with the following SP if there are any color registration problems:
• SP1-004-007 (Development Motor Speed–[K] L Thick)
G130R597.WMFF
[A]