Setup guide

Monitoring and Configuring the Printer
74
2
show
Use the “show” command to display network interface board configuration settings.
❖ View settings
msh> show
• If “-p” is added, you can view settings one by one.
Reference
p.95 “Configuring the Network Interface Board”
slp
Use “slp” command to view and configure SLP settings.
msh> slp ttl “ttl_val”
• You can search the NetWare server using SLP in the PureIP environment of
NetWare 5/5.1. Using the “slp” command, you can configure the value of
TTL which can be used by SLP multicast packet.
• The default value of TTL is 1. A search is executed only within a local seg-
ment. If the router does not support multicast, the settings are not available
even if the TTL value is increased.
• The acceptable TTL value is between 1 and 255.
smb
Use the “smb” command to configure or delete the computer or workgroup
name for SMB.
❖ Computer Name settings
msh> smb comp “computer name”
• Set computer name using up to 15 characters. Names beginning with
“RNP” or “rnp” cannot be entered.
❖ Working Group Name settings
msh> smb group “work group name”
• Set workgroup name using up to 15 characters
❖ Comment settings
msh> smb comment “comment”
• Set comment using up to 31 characters.
❖ Notify print job completion
msh> smb notif {on | off}
• To notify print job completion, specify “on”. Otherwise, specify “off”