Setup guide

Using NetWare
27
1
F Set up the network connection to a printer.
G On the [Available Options] menu, click [Print Server Information], and then press
the {Enter} key.
H To create a new print server, press the {Insert} key, and then enter a print
server name.
For a currently defined print server, select a print server in the [Print Server]
list.
Use the same printer name specified using NIB Setup Tool.
I From the [Print Server Information] menu, select [Print Server Configuration].
J From the [Print Server Configuration] menu, select [Printer Configuration].
K Select the printer indicated as [Not Installed].
Use the same printer number specified as the remote printer number using
NIB Setup Tool.
L To change the printer name, enter a new name.
A name “printer x” is assigned to the printer. The “x” stands for the number
of the selected printer.
M As type, select [Remote Parallel, LPT1].
The IRQ, Buffer size, Starting form, and Queue service mode are automatical-
ly configured.
N Press the {Esc} key, and then click [Yes] on the confirmation message.
O Press the {Esc} key to return to [Print Server Configuration Menu].
P Assign print queues to the created printer.
Q From [Print Server Configuration Menu], select [Queues Serviced By Printer].
R Select the printer created.
S Press the {Insert} key to select a queue serviced by the printer.
You can select several queues.
T Follow the instructions on the screen to make other necessary settings.
Following these steps, check that the queues are assigned.
U Press the {Esc} key until "Exit?" appears, and then select [Yes] to exit
PCONSOLE.
V Start the print server by entering the following from the console of the Net-
Ware server.
If the print server is in operation, quit and restart it.