Setup guide

Monitoring and Configuring the Printer
104
2
phy release file open failed. Replacing the network interface board is re-
quired. Contact your sales or service repre-
sentative.
Print queue <print queue name> cannot be
serviced by printer 0, <print server name>
(In the print server mode) The print queue
cannot be established. Make sure that print
queue exists on the specified file server.
Print server <print servername>has no printer. (In the print server mode) The printer is not as-
signed to the print server. Using NWadmin,
assign the printer, and then restart it.
print session full No more print jobs can be accepted.
Printer <printer name> has no queue (In the print server mode) The print queue is
not assigned to the printer. Using NWadmin,
assign the print queue to the printer, and then
restart it.
pserver start. (NetWare) (In the print server mode) The NetWare serv-
ice has started.
Required file server (<file servername>) not
found
The required file server is not found.
restarted. The lpd service has started.
sap enable, saptype=<SAP type>, sap-
name=<SAP name>
The SAP function has started. The SAP packet
is issued to advertise the service on the SAP ta-
ble on the NetWare server.
session <community name> not defined. The requested community name is not de-
fined.
session_ipx <community name> not defined. The requested community name is not de-
fined.
Set context to <NDS contextname> An NDS context name has been set.
shutdown signal received. network service re-
booting...
The network service is rebooting.
smbd start. (NETBIOS) The smbd service has started.
SMTPC: failed to get smtp server ip-address. The SMTP server IP address could not be ob-
tained. This could be because:
• The specified DNS server could not be
found.
• No connection to the network has been es-
tablished.
• The specified DNS server could not be
found.
• An incorrect DNS server is specified.
• The specified SMTP server IP address
could not be found in the DNS server.
Message Problem and solutions