Operating instructions

Network Settings
27
1
Settings Required to Use the Network Delivery Scanner
This section lists the settings required for delivering data to network.
Ethernet
This section lists the settings required for delivering data to network with ether-
net cable.
For details about how to specify the settings, see “Interface Settings” and “File
Transfer”.
Note
❒ In [Effective Protocol], check that the protocol you want to use is set to [Active].
❒ [LAN Type] is displayed when the wireless LAN interface board is installed.
When both ethernet and wireless LAN (IEEE 802.11b) are connected, the se-
lected interface takes precedence.
❒ If [Delivery Option] is set to [On], check that IPv4 Address is set.
Reference
p.58 “Interface Settings”
p.68 “File Transfer”
Menu User Tool Setting Requirements
Interface Settings/Network Machine IPv4 Address Neccessary
Interface Settings/Network IPv4 Gateway Address As required
Interface Settings/Network DNS Configuration As required
Interface Settings/Network DDNS Configuration As required
Interface Settings/Network Domain Name As required
Interface Settings/Network WINS Configuration As required
Interface Settings/Network Effective Protocol Neccessary
Interface Settings/Network Ethernet Speed As required
Interface Settings/Network LAN Type Neccessary
Interface Settings/Network Permit SNMPv3 Communication As required
Interface Settings/Network Permit SSL/TLS Communication As required
Interface Settings/Network Host Name As required
File Transfer Delivery Option As required
File Transfer Fax RX File Transmission As required
File Transfer Scanner Resend Interval Time As required
File Transfer Number of Scanner Resends As required