Operating instructions

Connecting the Machine
24
1
Note
❒ In [Effective Protocol], check that the protocol you want to use is set to [Active].
❒ [LAN Type] is displayed when the wireless LAN interface board is installed. If
both ethernet and wireless LAN (IEEE 802.11b) are connected, the selected in-
terface takes precedence.
❒ When [POP before SMTP] is set to [On], also make setting for [Reception Protocol]
and [POP3 / IMAP4 Settings].
❒ When setting [POP before SMTP] to [On], check[POP3] port number in [E-mail
Communication Port].
Reference
p.58 “Interface Settings”
p.68 “File Transfer”
Settings Required to Use Scan to Folder Function
This section lists the settings required for sending file.
Ethernet
This section lists the settings required for sending file with ethernet cable.
For details about how to specify the settings, see “Interface Settings” and “File
Transfer”.
Menu User Tool Setting Requirements
Interface Settings/Network Machine IPv4 Address Neccessary
Interface Settings/Network IPv4 Gateway Address Neccessary
Interface Settings/Network DNS Configuration As required
Interface Settings/Network DDNS Configuration As required
Interface Settings/Network Domain Name As required
Interface Settings/Network WINS Configuration As required
Interface Settings/Network Effective Protocol Neccessary
Interface Settings/Network Ethernet Speed As required
Interface Settings/Network LAN Type Neccessary
Interface Settings/Network Permit SNMPv3 Communication As required
Interface Settings/Network Permit SSL/TLS Communication As required
Interface Settings/Network Host Name As required
File Transfer Scanner Resend Interval Time As required
File Transfer Number of Scanner Resends As required