Operating instructions

User Tools (System Settings)
74
5
❖
❖❖
❖ SCSI Print (SBP-2)
When you print using the SCSI Print client function supported by Windows
2000 or Windows XP, you must set SCSI Print. For details, see the Network
Reference.
Note
❒ Default: Active
❒ When using the SCSI Print (SBP-2), setting the IP Address and the Sub-net
Mask is not required.
❖
❖❖
❖ Bidirectional SCSI Print
Specifies the printer's response mode and so forth for a status request when
using the IEEE 1394 interface.
Note
❒ Default: ON
❒ If this is set to "OFF", asynchronous functions will not work.
Interface Settings/IEEE 802.11b (Option)
Preparation
You must install the Wireless LAN board (option) into the machine.
The IEEE 1394 board (option) cannot be installed at the same time.
Note
❒ Be sure to make all settings simultaneously.
❖
❖❖
❖ Communication Mode
Specifies the communication mode of the Wireless LAN.
Note
❒ Default: 802.11 Ad hoc
❖
❖❖
❖ SSID Setting
Specifies SSID to distinguish the access point in the Infrastructure mode.
Note
❒ Default: ASSID
❒ If SSID is left blank for the 802.11b Ad hoc Mode or Ad hoc Mode, “ASSID”
is displayed.
❖
❖❖
❖ Channel
Specifies a channel when you select 802.11b Ad hoc mode or Ad hoc mode.
Note
❒ The channel can be set from 1 - 13.
❒ Default: 11