Operating instructions

Configuring the Network
31
2
When using the Wireless LAN Interface (option) in Infrastructure Mode
Note
❒ The network administrator must check the environment and set the Com-
munication mode, WEP key, and SSID correctly. For details on settings,
see "Using the IEEE 802.11b (Wireless LAN)" in the Network Printing
Guide.
❒ Enter the WEP key in hexadecimal. You can enter 10 digits for 64-bit data
or 26 digits for 128-bit data.
❒ Characters used for setting SSID are <ASCII 0×20 to 0×7e> which are case
-sensitive. You can enter up to 32 characters.
❒ You can also set the Infrastructure mode from the Web browser. For de-
tails on settings, see the Network Printing Guide.
A Make sure that [Network] is selected, and then press [LAN Type].
B Press [IEEE 802.11b], and then press [OK].
C Press [IEEE 802.11b].
D Press [Communication Mode].
E Press [Infrastructure], and then press [OK].
F Press [SSID Setting].
G Press [Enter SSID].
H Enter the SSID, and then press [OK].
I Press [WEP(Encryption)] if setting is required.
J Press [Active].
K Press [Enter the WEP key] and enter the WEP key.
L Press [OK].