Operating instructions

Where to Put Your Machine
127
7
Limitation
❒ Carefully move the machine. If
you do not, the machine might be
damaged or a stored file might be
deleted.
❒ Do not take off the holding stand.
❒ Protect the machine from strong
shock. This could damage the hard
disk and cause stored files to be de-
leted. As a precautionary measure,
files should be copied to another
computer.
Power Connection
R
WARNING:
R
CAUTION:
R
CAUTION:
• When the main switch is in the
Stand-by position, the optional
anti-condensation heaters are on.
In case of emergency, unplug the
machine's power cord.
• When you unplug the power cord,
the anti-condensation heaters turn
off.
• Make sure that the plug is firmly
inserted in the outlet.
• Voltage must not fluctuate more
than 10%.
• The socket-outlet should be in-
stalled near the equipment and
should be easily accessible.
Access to the Machine
Place the machine near the power
source, providing clearance as
shown.
1. Rear
*1
: more than 10 cm (4")
2. Right: more than 55 cm (22")
3. Front: more than 75 cm (29.6")
4. Left: more than 10 cm (4")
*1
The space required at the rear is from
the outside of the ventilation holes to
the wall.
Note
❒ For the required space when op-
tions are installed, contact your
service representative.
• Connect the machine only to
the power source described on
the inside front cover of this
manual. Connect the power
cord directly into a wall outlet
and do not use an extension
cord.
• Do not damage, break or make
any modifications to the power
cord. Do not place heavy ob-
jects on it. Do not pull it hard
nor bend it more than neces-
sary. These actions could
cause an electric shock or fire.
• Unplug the power cord from the
wall outlet before you move the
machine. While moving the ma-
chine, you should take care that
the power cord will not be dam-
aged under the machine.
• When you disconnect the power
plug from the wall outlet, always
pull the plug (not the cable).
1
2
3
4