Operating instructions

The factory default is [Auto]. If you need to change the transmitting speed depending on environment

you are using, select the appropriate transmitting speed.

10. Print a configuration page to confirm the settings made.

• For details about printing the configuration page, see p.33 "Test Printing".

Setting SSID

If [Infrastructure] or [802.11 Ad hoc] is selected for [Comm. Mode], set SSID to use for transmission.

Consult your network administrator for the SSID to use.

1. Press the [ ] or [ ] key to select [SSID], and then press the [ Enter] key.

If an SSID has been set, you can check the SSID setting.

2. Press the [ ] or [ ] key to select [Enter ID], and then press the [ Enter] key.

3. Press the [ ] or [ ] key to enter characters, and then press the [ Enter] key.

The number of character you have entered is displayed on the top right of the screen.

The characters that can be used are ASCII 0x20-0x7e (32 bytes), 16 digits.

4. Print a configuration page to confirm the settings made.

• SSID can also be set using a Web browser. For details, see the Web Image Monitor Help, and

"Configuring the Network Interface Board Using Web Browser" Software Guide.

• WEP key can also be set using a Web browser. For details, see Web Image Monitor Help.

• For details about printing the configuration page, see p.33 "Test Printing".

IEEE 802.11b (Wireless LAN) Configuration