Operating instructions

• Call your sales / service representative as soon as possible.

Replace Fusing Unit

It is time to replace the Fusing Unit.

• You can still print even if this message appears, but to ensure a good standard of printing, call your

sales / service representative as soon as possible.

Replace PCU

It is time to replace the Photoconductor Unit.

• Call your sales / service representative as soon as possible.

Replace Transfer Belt

It is time to replace the Transfer Belt.

• Call your sales / service representative as soon as possible.

Replace Waste Toner (TypeE)

It is time to replace the waste toner.

• Call your sales / service representative.

Reset Tray # correctly

The indicated paper input tray is not set correctly, or is not set.

• Set the indicated paper input tray correctly.

Reset Tray # or Form Feed

There is a problem with the tray.

• Load the tray with the correct paper or change the paper type/size using the dial or via the Paper

Input menu on the operation panel. Alternatively, select another tray using [Form Feed], or cancel the

job.

SC XXX-X Power Off On/Call Service if error reoccurs

The Service Code or SC number indicates the problem.

• Turn the power switch to Standby, and then to On.

• If the message appears again, call your service provider. Report the error code that appears.

SD authenticatn. failed

Authentication from the SD card has failed.

• Turn the power switch to Stand by, and then to On. If the message is displayed again, call your sales /

service representative.

SSID not entered

Wireless LAN's SSID is not entered.

9. Troubleshooting

102