Operating instructions

The entered number of characters for the WEP Key (ASCII entry) is incorrect.

• Enter the correct WEP key.

• See p.47 "IEEE 802.11b (Wireless LAN) Configuration".

Error: Enter 5 or 13 characters

The entered number of characters for the WEP Key (ASCII entry) is incorrect.

• Enter the correct WEP key.

• See p.47 "IEEE 802.11b (Wireless LAN) Configuration".

Error: Tray # or Form Feed

The selected tray is out of order.

• Select another tray using [Form Feed], or after canceling the job, turn the power switch to Stand by,

and then to On the power switch. If the error appears again, call your sales / service representative.

Hardware Problem Ethernet

The printer detected an ethernet error.

• Turn the power switch to Stand by, and then to On. If the message appears again, call your sales /

service representative.

Hardware Problem Finisher

Finisher is not functioning.

• Turn the power switch to Standby, and then to On. If the message appears again, call your sales /

service representative.

Hardware Problem Fin. Shift Tray

The Finisher Shift Tray has a problem when using shift function.

• Call your sales / service representative.

Hardware Problem HDD

The printer identified an HDD Board error.

• Call your sales / service representative.

Hardware Problem Interposer

The interposer has a motor problem.

• Turn the power switch to Stand by, and then to On. If the message appears again, call your service

provider.

Hardware Problem LCT

LCT has a problem with the transfer motor.

• Turn the power switch to Stand by, and then to On. If the message appears again, call your sales/

service representative.

9. Troubleshooting