INSTALLATION AND OPERATING MANUAL Translation of the original manual Series SCK Mechanical Seals external, single single with double lip seal on the wetted side single with lip seal on the atmosphere side, with quench Keep for future use! This operating manual must be strictly observed before transport, installation, operation and maintenance Subject to change without notice. Reproduction is generally permitted with indication of the source.
Series SCK, mechanical seal, external, single single with double lip seal on the wetted side single with lip seal on the atmosphere side, with quench Page 2 List of Contents List of Contents ........................................ 2 Relevant documents ................................. 2 1 Technical data ...................................... 3 5 Maintenance ......................................... 5 5.1 External, single mechanical seal ................. 5 5.1.1 Dismantling ...........................
Series SCK, 1 mechanical seal, external, single single with double lip seal on the wetted side single with lip seal on the atmosphere side, with quench Page 3 Technical data Manufacturer : Richter Chemie-Technik GmbH Otto-Schott-Str. 2 D-47906 Kempen Telephone: +49 (0) 2152 146-0 +49 (0) 2152 146-190 Fax: E-Mail: richter-info@idexcorp.com Internet: http://www.richter-ct.com Authorised person acc.
Series SCK, mechanical seal, external, single single with double lip seal on the wetted side single with lip seal on the atmosphere side, with quench 4 Commissioning / Shutdown 4.1 Initial commissioning See installation and operating manual for the series SCK. 4.2 Mechanical seals The design and material combination are specified in the data sheet. The proper condition of the components and the protective facilities must be ensured to prevent any risk from escaping medium.
Series SCK, 5 mechanical seal, external, single single with double lip seal on the wetted side single with lip seal on the atmosphere side, with quench Page 5 Maintenance The regulations of the mechanical seal manufacturer must always be observed. See also the installation and operating manual for the SCK series. In normal operations this seal should not drip. The leak should only be so minimal that it evaporates immediately.
Series SCK, mechanical seal, external, single single with double lip seal on the wetted side single with lip seal on the atmosphere side, with quench Pull the back plate 161 with the mating ring adapter 487 and mating ring 475/1 off the shaft sleeve. After undoing the nuts 920/3 with the washers 554/3, the mating ring adapter 487 is removed first. Then remove mating ring 475/1. Now pull the shaft sleeve 524 with the rotating unit 470/1 which is still installed off the shaft.
Series SCK, mechanical seal, external, single single with double lip seal on the wetted side single with lip seal on the atmosphere side, with quench 5.2.2 Assembly Observe notes in Section 5.1.2. Secure mating ring 475/1, intermediate ring 509/2, support ring 506 and mating ring adapter 487 on the back plate 161 with the stud screw 902/3, washer 554/3 and hex. nut 920/3. For sequence for back plate, see Sections 4.2 and 7.7.4 in the installation and operating manual SCK.
Series SCK, 6 mechanical seal, external, single single with double lip seal on the wetted side single with lip seal on the atmosphere side, with quench Faults Faults may result from inadmissible modes of operation. Such inadmissible modes of operation – even brief ones – may cause serious damage to the unit.
Series SCK, 7.
Series SCK, 7.
Series SCK, 7.
