Instruction Manual
Series Series KNAR/F, KNARP/F, KNAR-D/F, KNARP-D/F, Page 4
KNAR-S/F, KNARP-S/F
ASME
9520-082-en Revision 04
TM 7377 Edition 11/2008
1.1 Name plate, CE and body
markings
The stainless steel name plate is undetachably riveted
to the body.
If the operator attaches his identification, it must be
ensured that the valve matches the application in
question.
Example of name plate with CE marking:
No CE marking is permissible for the sizes ½“ and ¾“
the name plate therefore has no CE marking.
Example: Additional name plate KNAR, KNARP
Body identification :
The following are visible on the body according to DIN
EN 19 and AD 2000 A4:
Nominal size
Rated pressure
Body material
Manufacturer's identification
Melt number/Foundry identification
Cast date
1.2 V-control ball/stem unit
The advantage of a single-piece v-control ball/stem
unit is the play-free power transmission. This applies
in particular to plastic-lined components.
The end of the stem journal or flat pivot point is
marked with:
direction of flow
flow rate Kvs and Cv
lining material
As viewed from above, closing is in clockwise
direction.
1.3 Tightening torques
All screws greased, tighten in diametrically
opposite sequence!
The tightening torques for pipe screws and body
screws mentioned must not be exceeded. For an
exception, see Section 8
, Flange connection valve /
pipe is leaking.
The following tightening torques are recommended:
Packing screws
Tighten packing gland follower 503 until spring gland
follower 502 is in contact without any gap. In Bei 3", 4",
6" and 8" are 2 spring gland followers 502.
Pipe screws
Flange nom. size Screws Tightening torque
[inch] [ASME] [in-lbs] [Nm]
½" 4 x ½“ 45 5
¾" 4 x ½“ 55 6
1" 4 x ½“ 70 8
1½" 4 x ½“ 135 15
2" 4 x O“ 220 25
2½" 4 x O“ 265 30
3" 4 x O“ 400 45
4" 8 x O“ 310 35
6" 8 x ¾“ 710 80
8" 8 x ¾“ 1020 115
Body screws
Nom. Size Screws Tightening torque
[inch [ISO/DIN] [Nm] [in-lbs]
½"
4 x M12 35 310
¾"
4 x M12 35 310
1"
4 x M12 35 310
1½"
4 x M16 45 398
2"
4 x M16 45 398
3"
8 x M16 50 442
4"
8 x M16 60 531
6"
8 x M20 150 1330
8"
8 x M20 150 1330
Control characteristics
Direction of flow
Flow rate kvs and cv