Use And Care Manual

11
Installing the water heater
Hot and Cold Pipe Insulation Installation
Install the insulation on the cold water supply inlet and the
hot water outlet as shown in the illustration.
Hot Water
Outlet
Relief
Valve
Cold Water
inlet
Drain
Valve
Water Sensor
In order to detect the presence of
unwanted water, this water heater
is supplied with a built-in water
sensing circuit. The water sensor
rope is shipped in the warranty
bag for eld installation.
Remove water sensor rope from
the bag and attach to the connector
located near the lower access
panel. Place the rope in the
recommended drain pan and
secure to the pan bottom with
provided self adhesive clips.
When water is detected, the
electronic control will turn off
the heating elements, ash the
display backlight and turn on an
audible alarm.
Water Sensor
Rope Attachment
Point
Clips
Drain Pan