Use And Care Manual

3
The chart shown above may be used as a guide in
determining the proper water temperature for your
home.
!
DANGER: Households with small children,
disabled, or elderly persons may require a 120°F or
lower thermostat setting to prevent contact with
“HOT” water.
The temperature of the water in the heater is regulated
by the water heater interface control. To comply with
safety regulations the temperature was set at 120°F
before the water heater was shipped from the factory.
The illustration below shows the water temperature
setting.
Refer to the Operating Instructions in this manual
for detailed instructions in how to adjust the water
temperature.
DANGER: Hotter water increases the potential for
Hot Water SCALDS.
Time/Temperature Relationship in Scalds
Temperature Time To Produce a Serious Burn
120°F (49°C) More than 5 minutes
125°F (52°C) 1½ to 2 minutes
130°F (54°C) About 30 seconds
135°F (57°C) About 10 seconds
140°F (60°C) Less than 5 seconds
145°F (63°C) Less than 3 seconds
150°F (65°C) About 1½ seconds
155°F (68°C) About 1 second
Table courtesy of Shriners Burn Institute
DANGER
!
HOT
Water temperature over 125° F can
cause severe burns instantly or
death from scalds.
Children, disabled and elderly are
at highest risk of being scalded.
See instruction manual before
setting temperature at water
heater.
Feel water before bathing or
showering.
Temperature limiting valves are
available, see manual.
BURN
IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.
DANGER!
WATER TEMPERATURE SETTING
Safety and energy conservation are factors to be considered when selecting the water
temperature setting of water heater. Water temperatures above 125°F can cause severe
burns or death from scalding. Be sure to read and follow the warnings outlined on the
label pictured below. This label is also located on the water heater near the thermistor
access panel.
NOTICE: Mixing valves are recommended for reducing
point of use water temperature by mixing hot and
cold water in branch water lines. It is recommended
that a mixing valve complying with the Standard for
Temperature Actuated Mixing Valves for Hot Water
Distribution Systems, ASSE 1017 be installed. See page
16 for more details and contact a licensed plumber or the
local plumbing authority for further information.
Energy Saver Mode
StatusSettings
warm hot very hot
Service Mode
120°
!