Owner Manual

lPlease note that product specifications and design may change without prior
notice for the purpose of quality improvement.
lThere may be some joint war page and each product may experience different
coloration in the wood grain of the wood as frames are made of natural material.
lIf you find something wrong with this product, please let us know. Thank you!
Designed by:
Richell Corporation, Japan
Distributed by:
Richell USA, Inc.
Grand Prairie, Texas 75050
Phone [phone] Fax [phone]
Visit us at
www.richellusa.com
MADE IN VIETNAM
How to assemble
How to Open/Close the Door
※Make sure there is no loose connection or wobble
by shaking the top of the crate back and forth.
Attach Rubber Skid to the 2 places on each
Side Panel (on the side with Pins) to
prevent from sliding or/and scraches to
floor surface.
How to attach Rubber Skid
1.
Make sure Horizontal Wire Slat on Front and
Side Panels are facing outside when attached together.
① Insert Pin of Side Panel into Receiving Hole of
Front/Back Panel as shown in right figure.
②Then, align L-shaped Cut with the top corner of
Front/Back Panel. (Follow the arrow of ②, do not
sligh by pushing the front/back panel )
How to Assemble Panels
2.
L-shaped Cut
Receiving Hole
Pin
Horizontal Wire Slat
Front Panel
Back Panel
Horizontal Wire Slat
Insert Fixing Pin into Receiving Hole on the corner.
Repeat 2 and 3 with all 4 locations. Then, place the crate
on the Floor Tray.
How to Insert Fixing Pin
3.
4.
① Lift up the Sliding Lock.
② Then slide the Door to open.
Hook
Hook
The Door can be kept open by using Hook.
For Left Door
By turning Front Panel upside down,
the position of the Door can be switched
from left to right as shown below.
For Right Door
Side Panel
Rubber Skid
Pin
How to Attach Wire Top to the Crate
①Place the hooks of Back of Wire Top on the top frame of Back Panel.
②Place the Front of Wire Top on the top frame of Front Panel. Then, slide
the Wire Top Lock to close and lock. → Bring the Front of the Wire Top down
and slide to engage with the top of the Front Panel.
A
How to Open/Close Wire Top
Slide Wire Top Lock toward the Back Panel
to release.
Wire Top Lock
Hook
Wire Top
A
Fixing Pin
About
3/4 inch
Outside
Inside
Inside
Out
side
②
②
①
①
Lock
Open
Open
Close
Close
2