User manual

C.1.3 The Battery charger
The built-in battery charger is capable of charging the batteries quickly and
completely. A microprocessor controlled, 3 to 4 Step charging process ensures
the optimum charging of the batteries. The desired charging current can be set.
The battery charger can be used for lead-acid or gel batteries. Thanks to the
floating charge ability of your Invertek, The batteries can remain continuously
connected.
C.1.4 The solar charge regulator (opetional)
With the built-in solar regulator, the Invertek is a complete solar-power-center. In a
solar installation this regulator ensures that the batteries are charged correctly.
With the Invertek, batteries can be charged with a generator and with the solar
modules at the same time. The charging of batteries with both energy sources is
carried out fully automatically.
C.1.5 Remote control
As an option, a remote control can be connected to your Invertek, All functions
The remote control is supplied with a 3m long cable. This cable can be up to 15m
long. (RS-485 interface) On the remote control output current and charging current
are also shown.
C.2 Battery connections
Lead-acid batteries are normally available in blocks of 2V, 6V or 12V. In most
cases, to generate the necessary operating voltage and the capacity of the
batteries for the Invertek many batteries have to be connected together in parallel
and or in series. Following three examples are shown:
-5-