User manual

I. Auxiliary Contacts
In the Invertek there are two built-in programmable power relay (AUX1, AUX2). The
potential-free change-over contact of this power relay is connected to the screw
terminals (AUX1 NO-NC-COM, AUX2 NO-NC-COM)
Maximum Contact load: -230Vac / 5Amp-30Vdc/7Amp
In the factory we program this output to be active when one these situations are
detected:
 Over temperature
 Overload
 Over or under voltage of batteries
 Invertek is turned off manually or with a fault, “RUN/STOP” LED RED lit
-27-
Over / Under Voltage of Batteries.
AC output overload.
Invertek over temperature.