User manual

WLS-C Wheel Loader Scale - Operation 29
4.10 Diagnostics
The “Sensors Check menu” allows viewing the status of all inputs and outputs.
1. Press and hold the Print/Enter button for 3 seconds to enter the User menu.
2. Scroll to the User menu from the operating screen.
3. Scroll down using the Partial/Minus button until you see the Sensors Check page.
Figure 4-9. Sensor Check Menu
4. Press and release the Print/Enter button to enter the sub-menu.
Proximity
To select the second Proxy press and release the Print/Enter button.
• Proxy 1 (to visualize the status of the 1stproximity switch)
• Proxy 2 (to visualize the status of the 2ndproximity switch)
The Proximity status is normally Off, however during the weighing cycle, they become active, the status is On
momentary.
On-Off Outputs
To select the Out 4 sub-menu, press and release the Print/Enter button.
• Buzzer (to visualize the status WLS-C internal buzzer, On when active)
• Out 4(to visualize the printer’s power supply status if active or not, On when active).
Pressure Sensors
To select the Press High, Boom Angle, Chassis Angle sub-menu by press and release the Print/Enter button.
• Press Low (to visualize the output value from the piston pressure transducer)
• Press High (to visualize the output value from the rod pressure transducer, if equipped.)
• Boom Angle (to visualize the output value from the boom ASC angle sensor.)
• Chassis Angle ( to visualize the output from the Chassis ASC angle sensor.)
4.11 Printing the Ticket
Use the following procedure to print a ticket.
1. Press and release the Print/Enter button (in the operation page) to activate the printing of the ticket.
The printed ticket will show the following details:
Figure 4-10. Printer Ticket Showing Progressive Number of Printed Tickets