User manual

20 WLS-C Wheel Loader Scale

NOTE: Once the loaded calibration of 10 lifts is completed you must save the data to the memory.

Knownload is set based on what the measurement is used. Example: weight is 4230 lbs enter 4230 in knownload.

If load is 2.31 ton enter 231.

3.7 Menu Flow Chart

Figure 3-11. Calibration Menu Flow

KnownLoad2 Set the known load for calibration 2(if available): insert the value according to the machine’s

capacity, keeping in mind the decimals to be displayed, and the resolution preferred (this value

can also be set at the completion of the calibration).

LT2

point

Displays the number of lifts performed at decreasing speed, which will correspond to the number

of points recorded in loaded calibration 2 table, (refer LT2 xxxx: -xxxxx).

LT2 xxxx: -xxxxx Allows viewing the complete loaded calibration 2 table. It is possible to scroll through the table by

selecting the index number.

Delete Cal. 1 Used to delete calibration 1 data.

Delete Cal. 2 Used to delete calibration 2 data.

Save Save permanently all modifications to the loaded calibration.

1. Table loaded calibration 1 - First machine

2. Table loaded calibration 2 - Second machine, if exists

Setting Description

Table 3-4. Loaded Calibration Settings

Operating Screen

Operation Menu

Calibration

Machine

Setting

Static

Setting

Dynamic

Setting

Angle

Setting

Weighing

Mode

Advanced

Setting

Empty Cal Loaded Cal

Protected by

Advanced