User manual

14 WLS-C Wheel Loader Scale
3.0 Calibration
To calibrate the WLS-C, you must enter calibration mode. This allows you to alter system settings.
3.1 Entering Calibration Mode
Use the following procedure to access the calibration menu from the operating screen.
1. Press and hold the Print/Enter button until the User Menu appears.
2. Scroll down the menu list using the Partial/Minus button to reach the Setting Menu.
Figure 3-1. Setting Menu
3. Press and release the Print/Enter button to enter the menu.
The display indicates CAL: PIN 0.
Figure 3-2. Enter Calibration PIN
4. Enter the password 4482 to access the calibration area. See “Setting New Values” on page 21. to
complete changes.
Figure 3-3. Calibration PIN Entered
Once the values are entered, follow the procedure below to confirm it.
1. Press and release the Print/Enter button to confirm the changes made.
The asterisk will disappear.
2. Press and release the Partial/Minus button.