User manual

WLS-C Wheel Loader Scale - Installation 9
Figure 1-18. Angle Sensor Installed On Support Arm
NOTE: Angle sensors should be installed in line with the opening and bolt for the arm and must parallel on the boom.
There are 3 bolts on the angle sensor: 1 on top and 2 on the bottom. The angle sensor should be installed so that the 1
bolt side faces up and the side with 2 bolts faces down. If installed correctly, the wire will be toward the cab of the
loader. See Figure 1-19 on page 9.
Figure 1-19. Angle Sensors Installed
Angle Sensor
Angle Sensors