Specifications

54 RL-TA Series Operation Manual
16.10 Interval Output Function
This function outputs data at regular intervals. Intervals can be set in hours, minutes, or seconds. To use
the interval output function, select [61. o.c. A] or [61. o.c. b]
in Function 1.
1. Call the interval function.
Press and hold the Target key for a few seconds. When
[Int. UAL] is displayed, release the key for a few
seconds.
The display indicates an interval with the leftmost digit
blinking.
2. Set an interval.
Press the Zero/Tare key to change the value of the
blinking value.
Function key to blink the next digit to the right.
If you press the Function key while the rightmost digit is
blinking, the leftmost digit blinks.
Pressing the Print key cancels the entered
value and returns the display to measurement
mode.
3. Save the settings, and go back to measurement mode.
Press the Target key.
1. The output stops while Function 1 or 2 are displayed.
2. [6 - Err] is displayed if the interval is set to “0”. Set another interval.
(Press any key to delete the error message.)
* The current time can be output with the measurement data. To output the time with the measurement
data, refer to 16.7: “Time Stamp Output” on page 54.